Four Jaw Chucks

Accepts any jaws that will fit a VM100 chuck (jaws sold separately) The VM90 chuck is for those who prefer to operate the chuck using the quick- acting TommyBars (levers), which saves time when mounting and dismounting. The VM90's compact size makes it...

The VM100 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the scroll. Keyed chucks cannot be beaten when is comes to holding power. The totally enclosed back assures...

The VM100 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the scroll. Keyed chucks cannot be beaten when is comes to holding power. The totally enclosed back assures...

Direct thread 1-1/4"x8tpi. This chuck will thread on most full size lathes without an adapter. The VM100 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the scroll...

The VM120 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 5 to 1 ratio of the scroll. Keyed chucks cannot be beaten when is comes to holding power. The totally enclosed back assures...

The VM120 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 5 to 1 ratio of the scroll. Keyed chucks cannot be beaten when is comes to holding power. The totally enclosed back assures...

This chuck uses the same jaws as the VM120. Click HERE for a listing of compatible jaws The VM150 has two actions, one to quickly open and close the chuck as though it was lever operated (fully opens within 3 revolutions), the other to tighten using the...

This chuck uses the same jaws as the VM120. Click HERE for a listing of compatible jaws The VM150 has two actions, one to quickly open and close the chuck as though it was lever operated (fully opens within 3 revolutions), the other to tighten...

Vicmarc Requires a minimum order of 100 of these chucks. Since not many people use such a small chuck on a full size lathe, we would most likely never sell through that many.

Direct thread 1-1/4"x8tpi. This chuck will thread directly on to most full size lathes sold in the USA without an adapter. The VM120 T- Bar Allen Key operated chuck provides one - hand tightening along with tremendous gripping power provided by the 5 to...

This chuck uses the same jaws as the VM120. Click HERE for a listing of compatible jaws Direct thread 1-1/4"x8tpi. This chuck will thread directly on to most full size lathes sold in the USA without an insert or adapter. The VM150 has two...